Oil mods Archives - Dick Miller Racing

TS-5005 Billet aluminum oil fill tube

GarciaJ — Tue, 07 Jan 2025 17:32:03 +0000

Press in Oldsmobile oil fill tube.
Billet aluminum with billet aluminum screw on top.
Baffle in the block is no longer necessary.

The post TS-5005 Billet aluminum oil fill tube appeared first on Dick Miller Racing.

DMR-5580-S

GarciaJ — Tue, 07 Jan 2025 17:29:52 +0000

The post DMR-5580-S appeared first on Dick Miller Racing.

DMR-5580

GarciaJ — Tue, 07 Jan 2025 17:28:15 +0000

Aluminum valley tray. This helps keep hot oil off the bottom of the intake, which is a must when NOT using a factory-style (bath tub) intake gasket.
Use with DMR-279101, DMR-279102 intake gaskets. Will bolt into factory holes when using a flat tappet cam.
If you are running a roller cam, you will also need the DMR-5580-S mounting stud kit to mount the tray higher to clear roller lifters.
Some 350 small blocks will need the block drilled and taped to 1/4-20 squarely over #2 and #4 cam bearings.

The post DMR-5580 appeared first on Dick Miller Racing.

DMR-5104

GarciaJ — Tue, 07 Jan 2025 01:12:35 +0000

Camshaft bearing oil restrictors. Inserts into block underneath main bearings 1 through 4. Reduces oil to cam bearings, that are over oiled. leaving more oil for the main bearings. Use RED Loctite on the knurled end and install with the knurler end last until it bottoms out in the passageway. There is a step in passage way for it to bottom out.

The post DMR-5104 appeared first on Dick Miller Racing.